Video Intercom with Keypad (VID8)

IP Rated, Vandal Resistance, Stainless Steel, Night Vision CCD Camera unit with built in illuminated Keypad. Four wire connection from Outdoor camera to Indoor monitor. Check our Gel filled CAT5E Shielded Cable to use with this intercom.

• Two Outputs can be used for Gate Opener and Electric Lock (if use with our VID91M or VID92M)
• Stainless Steel vandal resistance outdoor unit
• 8.5mm Colour CCD camera with Infrared night vision video
• Built in Keypad with Illuminated key pad to open the gate.
• Waterproof to IP55 rating
• Flush Mount or Surface Mounting facility
• Gate open connection from Outdoor Unit
• Connection facility for 4 monitors

Installation:

Take extra precautions if this Intercom to install without Mounting Bracket. Use silicone sealant to seal screw holes of back polymer cover. Also get the wires from bottom of the back cover.

If using surface mounting bracket, back side of this bracket has self- compressing sponge rubber to seal water getting in through wire hole. It is important to make sure back sponge rubber completely seal mounting surface. Wires coming into the hole need to come in from lower elevation to the hole, to stop water getting inside intercom. Also drill a small hole bottom of the Mounting Bracket to drain condensate water.

Technical Specifications:

• Operating voltage: DC14.5V (supplied by Indoor monitor & gate opener)
• Operating temperature: -20 to +55℃
• Camera: 1/3"CCD
• Communication mode: Duplex communication
• Maximum length of the cable with indoor monitor: 70M
• Talking time: 60s
• Dimension: 195 X 100 X 55 mm

Few different Indoor Monitors available for this intercom but not included with this unit.